MTI 527W - Operation; Operating Conditions

User Manual | MTI 527, 527W, &526 9
GOOD
ADJUST
13. (Seamless Upholstery
Only) Align the back portion
of the back/seat cushion
with the top edge of the
back of the chair. Press
cushion down.
14. (Seamless Upholstery
Only) Align the seat portion
of the back/seat cushion
with the front edge of the
seat of the chair. Press
cushion towards foot if
necessary.
15. Raise the back of the
chair and verify alignment
of back cushion. Adjust if
necessary.
16. With the footrest
retracted, push the foot
cushion against the seat
cushion and lower the foot
cushion into place. Verify
the cushion is centered.
17. Attach the arm cushion
to a slide-back arm with the
(4) screws and lock washers
provided using a phillips
screwdriver.
18. Repeat step 17 for
opposite arm.
19. (Swivel base chairs only.)
Remove swivel bolt with
9/16” wrench.
Keep the bolt for use while
the chair is not powered.
OPERATION
Operating Conditions
Ambient Temperature +10°C to +40°C (+50°F to +104°F)
Relative Humidity 30% to 75% (non-condensing)
Atmospheric Pressure 700hPa to 1060hPa (0.69atm to 1.05atm)