Installation and Operational Manual • Designer Collection • Shower Systems
mtibaths.com / 5
Installation Instructions – General
WARRANTY CARDS
Read all instructions before installing the shower pan or any portion of the shower system. MTI recommends using
a professional installer for this product. Installer/product owner is responsible for complying with all state and local
codes.
WARNING: Certain cleaning products will permanently damage the surface. Read product label carefully before
using any cleaning product. Never use anything abrasive, aerosol sprays or any product that is described as
“scrubbing bubbles.” Please see ‘Care & Cleaning Instructions’ on pg. 9.
•
Inspect product(s) thoroughly.
•
Damage from shipping or delivery must be reported to carrier immediately. Do not install damage unit(s). MTI is
not responsible for damage that occurs during transit.
•
Factory defect must be reported to factory before unit is installed. Defects or damage claimed after installation
will be excluded from warranty.
•
Measure shower pan on site carefully to ensure proper fit into planned opening. Bottom of the shower pan may
be slightly larger than the top per product specification sheet. Specifications are subject to change without
notice. MTI is not responsible for any preparatory labor or materials.
•
Always protect product(s) from construction damage by using a protective cover. Damage, including chips and
scratches incurred at the jobsite are excluded from warranty, but may be repaired by a qualified technician at
the owner’s expense. Do not stand in the shower pan prior to installation or store materials in the unit during
construction. Shower pans and other shower system products are intended for indoor use and warrantied for
indoor installation in a climate controlled environment only.
•
Do not store product in temperatures below 32º Fahrenheit.
BEFORE INSTALLING
IMPORTANT: Locate and
note your serial number on
the cover of this manual for
any future service needs.
Never leave a running shower unattended.
To Next Page
Loading...