7.14 Lube Oil System, Lube Oil Circuit 97
7.14.1 Engine oil – Level check 97
7.14.2 Engine oil – Change 98
7.15 Oil Filtration / Cooling 99
7.15.1 Engine oil filter – Replacement 99
7.16 Coolant Circuit, General, High-Temperature
Circuit 100
7.16.1 Engine coolant drain and venting points 100
7.16.2 Engine coolant – Level check 103
7.16.3 Engine coolant – Change 104
7.16.4 Engine coolant – Draining 105
7.16.5 Engine coolant – Filling 106
7.16.6 HT coolant pump – Relief bore check 107
7.16.7 Engine coolant – Sample extraction and
analysis 108
7.17 Low-Temperature Circuit 109
7.17.1 Charge-air coolant – Draining 109
7.18 Raw Water Pump with Connections 110
7.18.1 Raw water pump – Relief bore check 110
7.19 Engine Mounting / Support 111
7.19.1 Engine mounting – Checking securing screws
for firm seating 111
7.19.2 Engine mounting – Checking condition of
resilient mounts 112
7.20 Belt Drive 113
7.20.1 Drive belt – Condition check 113
7.21 Battery-Charging Generator 114
7.21.1 Battery-charging generator drive – Drive belt
replacement 114
7.22 Wiring (General) for Engine/Gearbox/Unit 115
7.22.1 Еngine wiring ‒ Check 115
7.23 Accessories for (Electronic) Engine
Governor / Control System 116
7.23.1 Engine governor and connectors – Cleaning 116
7.23.2 EMU and connectors – Cleaning 117
7.23.3 Engine governor plug connections – Check 118
7.23.4 Engine Monitoring Unit EMU 8 – Plug
connections check 119
7.23.5 Interface module EIM plug connections –
Check 120
7.23.6 Engine Control Unit – Self-test 121
7.23.7 Engine governor ECU 9 – Removal and
installation 122
7.23.8 Engine Monitoring Unit – Removal and
installation 123
7.23.9 Engine Interface Module EIM – Removal and
installation 124
7.23.10 Diagnostic features of EIM 125
8 Appendix A
8.1 List of abbreviations 128
8.2 MTU contact persons/service partners 130
9 Appendix B
9.1 Special Tools 131
9.2 Index 138
4 | Table of Contents | MS150119/00E 2014-08
DCL-ID: 0000033801 - 001
To Next Page
Loading...
Need help?
General