EasyManua.ls Logo

MTU 12V 2000 C66 - Page 4

MTU 12V 2000 C66
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.11.2 Centrifugal oil filter – Cleaning and filter
sleeve replacement 72
6.12 Coolant Circuit, General, High-
Temperature Circuit 74
6.12.1 Drain and vent points 74
6.12.2 Engine coolant – Level check 79
6.12.3 Engine coolant – Change 80
6.12.4 Engine coolant – Draining 81
6.12.5 Engine coolant – Filling 82
6.12.6 Engine coolant pump – Relief bore check 84
6.12.7 Engine coolant – Sample extraction and
analysis 85
6.12.8 Coolant filter – Replacement 86
6.13 Low-Temperature Circuit 87
6.13.1 Intercooler – Vent and drain points 87
6.13.2 Charge-air coolant – Level check 88
6.13.3 Charge-air coolant – Change 89
6.13.4 Charge-air coolant – Filling 90
6.13.5 Charge-air coolant – Draining 92
6.13.6 Charge-air coolant pump – Relief bore check 93
6.14 Belt Drive 94
6.14.1 Drive belt – Condition check 94
6.14.2 Drive belt – Tension check 95
6.14.3 Drive belt – Tension adjustment 96
6.14.4 Drive belt – Replacement 97
6.15 Battery-Charging Generator 98
6.15.1 Battery-charging generator drive – Drive belt
replacement 98
6.16 Fuel Supply System 99
6.16.1 Water drain valve – Check 99
6.16.2 Differential pressure gauge – Check 100
6.16.3 Water level probe (3-in-1 rod electrode) –
Check 101
6.16.4 Pump capacity – Check 102
6.16.5 Coalescer filter element – Replacement 103
6.17 Engine Governor 105
6.17.1 Engine governor – Overview 105
6.17.2 Engine governor – Removal 106
6.17.3 Engine governor – Installation 107
6.17.4 Engine governor – Checking plug-in
connections 108
6.18 Wiring (General) for Engine/Gearbox/Unit 109
6.18.1 Engine wiring – Check 109
6.18.2 Lambda, NOx and humidity sensors –
Overview 110
6.18.3 Lambda sensor – Replacement 111
6.18.4 NOx sensor – Replacement 113
6.18.5 Humidity sensor – Replacement 115
6.19 Accessories for (Electronic) Engine
Governor / Control System 117
6.19.1 CDC parameters – Reset with DiaSys® 117
6.19.2 Engine governor and connectors – Cleaning 118
6.19.3 Engine governor – Checking plug-in
connections 119
7 Appendix A
7.1 List of abbreviations 120
7.2 MTU contact persons/service partners 123
8 Appendix B
8.1 Special Tools 124
8.2 Index 134
4 | Table of Contents | MS150094/01E 2012-08
DCL-ID: 0000007590 - 003

Table of Contents

Related product manuals