What to do if there is coolant discharge at intercooler of MTU 16V4000G94F?
If you notice coolant discharge at the intercooler of your MTU Engine, and it seems like a major coolant discharge due to leaking, contact service.
General| Engine Model | 16V4000G94F |
|---|---|
| Engine Type | Diesel |
| Configuration | V16 |
| Rated Speed | 1800 rpm |
| Number of Cylinders | 16 |
| Stroke | 210 mm |
| Cooling System | Water-cooled |
| Aspiration | Turbocharged |
| Emissions Compliance | US EPA Tier 2 |
General safety rules and warnings applicable to all products.
Specific safety requirements for power generation applications.
Outlines requirements for personnel involved in operation, maintenance, and assembly.
Safety guidelines for initial installation, startup, and ongoing operation.
Safety rules for performing assembly, maintenance, and repair tasks.
Safety measures for fire prevention, environmental protection, and handling fluids.
Procedures and safety precautions for transporting the engine/generator unit.
Details on proper lifting points and procedures to ensure safe lifting operations.
Details the engine management and monitoring system, including the ECU 9.
Step-by-step procedure for putting the engine into operation after a long period of disuse.
Procedure for re-commissioning the engine after a scheduled service interruption.
Instructions for starting the engine in manual mode for test runs.
Procedure to follow when re-starting the engine after an automatic safety shutdown.
Explains how to use the safety system override function in critical situations.
Guidelines for monitoring the engine's operation and detecting potential issues.
Procedure for initiating an emergency start of the engine using override mode.
Steps for safely stopping the engine in manual mode after a test run.
Instructions for performing an emergency engine stop.
A table listing maintenance tasks, items, options, and references to detailed procedures.
A guide to diagnosing and resolving common engine issues.
Explains fault messages from the ADEC (ECU 9) engine governor and their corrective actions.
Step-by-step guide on how to manually bar the engine.
Instructions for cranking the engine using the starting system.
Procedure for conducting an engine test run after assembly or repair.
Detailed steps for performing an endoscopic examination of the cylinder liner.
Procedure for checking and adjusting valve clearance.
Procedure for filling the HP fuel pump with engine oil.
Steps for replacing an engine injector.
Detailed procedure for removing and installing engine injectors.
Procedure for venting the low-pressure fuel system.
Procedure for replacing the fuel filter element.
Steps for replacing the additional fuel filter.
Steps for replacing the filter element in a switchable fuel prefilter.
Steps for replacing the filter element in a non-switchable fuel prefilter.
Procedure for venting the fuel prefilter.
Steps for removing and installing the air filter.
Procedure for changing the engine oil.
Instructions on how to check the engine oil level.
Procedure for replacing the engine oil filter.
Procedure for checking the engine coolant level.
Steps for changing the engine coolant.
Procedure for draining the engine coolant.
Steps for filling the engine coolant.
Procedure for checking the charge-air coolant level.
Steps for changing the charge-air coolant.
Procedure for draining the charge-air coolant.
Steps for filling the charge-air coolant.
Instructions on resetting drift correction parameters using DiaSys®.
To Next Page
