Mueller ISOBUS SPRAYER-Controller MAXI 3.0 - BOOM Alarms; SPRAYER Alarms

9
Alarm messages
104
V1.20170116
30303187-02-EN
Text of alarm message
Meaning
No angle sensor signal.
In the third calibration step, the angle sensor did not detect a change in the signal.
Outlets are swapped.
The hydraulic valves were connected wrong.
Sensors are disturbed.
Short signal interruption with all sensors
BOOM
Text of alarm message
Meaning
BOOM
Out of transport position.
The alarm is coupled to the Id37 input function. Display via graphic in the boom
and alarm message.
BOOM
No locking.
Alarm appears when no signal is received from the boom locking sensor.
Defective angle sensor.
Alarm when boom height control system is configured but the boom potentiometer
is recognized as defective.
SPRAYER
Text of alarm message
Meaning
Low tank content.
The volume of spray liquid in the tank has fallen below the "Tank level alarm".
SPRAYER
Pump speed is too low.
Check the pump speed.
Switch on the pump.
Increase the pump speed.
SPRAYER
Pump speed is too fast.
Check the pump speed.
Decrease the pump speed.
Boom folding forbidden: The speed is
too high.
The boom may only be folded and unfolded when the sprayer is at a standstill.
SPRAYER
Pump oil level.
Alarm appears when a sensor detects a certain oil level. The oil level depends on
the implement manufacturer and the installation of the sensor.
The compressor is too slow.
The compressor is slower than the defined value.
The compressor is too fast.
The compressor is too fast.
Filter pressure too high.
The pressure switch on the filter is sending an error message.
The left ladder is not in transport
position.
Static signal from a sensor that checks the position of the ladder.