Configuring the job computer
Configuring the units
⇨ The following screen appears:
⇨ The red dot CRP_2 marks the first boom.
2. On the line above the drawing, select whether the second boom is located in front of or behind
the first boom (looking in the direction of travel): "2nd boom, behind the 1st" or "2nd boom, front
of 1st"
3. Measure the distance between CRP_2 and the second boom (ERP) and enter this value.
Configuring the units
You can configure all of the units that are displayed on the terminal. You can select between various
metric and imperial units.
1. On the work screen, press:
> > > >
⇨ The "UNITS" screen appears.
⇨ On the screen, you will see which categories and subcategories can be configured.
2. Enter the settings required.
3. You have the option of configuring the parameters "Number of decimals" and "Decimal (fixed)"
for each category and subcategory.
⇨ All of the displayed values will be converted and displayed in the configured units.
Number of decimals
Enter how many decimal places should be displayed.
Decimal (fixed)
Activate this parameter if the decimal point should not be automatically shifted. The decimal places
then also remain even with larger numbers.
To Next Page
Loading...
Need help?
General
