Vario-Select
No overlap in Vario mode: Change
nozzles or set a wider pressure range.
The installed nozzles are not capable of reaching all of the target rates in the
selected range. You may require different nozzles.
See: Before you buy nozzles - check the possible application rates [➙ 74]
Check also if the installed nozzles were properly selected:
Configuring the nozzles on the multiple nozzle holder [➙ 78]
Vario mode requires at least 2 nozzles.
Ensure that at least two nozzles are installed on each nozzle holder and that
these nozzles are also set in the software. See: Configuring the nozzles on the
multiple nozzle holder [➙ 78]
Without assignment
Enter the user password to continue.
The setting is password-protected.
Enter the service password to
continue.
The setting is password-protected.
To Next Page
Loading...
Need help?
General
