EasyManua.ls Logo

Mueller MLR010002N - Parts Overview; Anti-Calc System; Anti-Drip System; Before Use

Mueller MLR010002N
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ANTI-CALC SYSTEM | 54 | PARTS OvERvIEw
PARTS OVERVIEW
BEFORE USE
Power Cord
Temperature Dial
Water Tank
Filling Cup
Self-Cleaning
Precision Stainless
Steel Soleplate
Spray
Nozzle
Water
Inlet
Cover
Steam
Selector
Spray Button
Burst of Steam
Button
Auto
Shut-Of f
Indicator
Retract
Button
Temperature
Indicator
Light
AUTOMATIC SHUTOFF
A special resin filter inside the Water Tank softens the water and
prevents scale build-up in the plate. The resin filter is permanent;
it does not need replacing.
The Auto Shut-Off indicator will automatically show a flickering green
light if the Steam Iron is tipped over or placed horizontally for more then
30sec or vertically for 8 min. In this case, the Steam Iron will produce
a warning sound and will automatically switch off.
As soon as you move the Steam Iron, the Auto Shut-Off will turn off and the
Steam Iron will start working again.
With the Anti-Drip system, you can perfectly
iron even the most delicate fabrics.
ANTICALC SYSTEM
ANTIDRIP SYSTEM
PLEASE NOTE!
Mueller irons are designed to use a REGULAR TAP WATER
(up to 12 grains of hardness). If your water is harder than
this, we recommend mixing tap water with distilled water
(1:1 ratio), which reduces the hardness; or just use
inexpensive bottled water.
Do not use chemical additives, scented substances,
or decalcifiers.
Always iron delicate fabrics at low temperatures. The plate may cool down to
the point where no more steam comes out, leaving drops of boiling water that
can leave marks or stains on the fabric. In these cases, the Anti-Drip system
automatically activates to prevent vaporization, so that you can iron the most
delicate fabrics without risk of spoiling or staining them.
30
sec
8
min
It is normal for a small amount of smoke to be
produced the first time the Steam Iron is used.
This will quickly disappear.
To avoid damage to clothes from dust or dirt that may
collect in the Steam Iron: before the first use or after
the Steam Iron has been stored for some time, first
iron an old cloth, testing both the “Spray” and the
“Burst Of Steam” features.
NOTE: Remove the transparent Soleplate
protective foil.
Please read the instructions and the “Important
Safety Instructions” carefully.