Mueller MLR010002N - Steam Ironing; Preparations; Filling with Water; Selecting the Temperature

STEAM IRONING | 76 | PREPARATIONS
Sort the laundry to be ironed according to the international symbols on the
garment label, or if this is missing, according to the type of fabric.
To save time, start ironing garments requiring a low temperature. This reduces the
waiting times (the Steam Iron takes less time to heat up than to cool down) and
eliminates the risk of scorching the fabric.
Filling With Water
– Check that the plug is disconnected from the socket.
– Move the Steam Selector to .
– Open the Water Inlet Cover.
– Hold the Steam Iron at an angle (~60°) and flip
open the Water Inlet Cover. Fill the Water Tank with
water (containing no additives) to the “MAX” water
level mark using the provided Filling Cup, and close
thecover.
PREPARATIONS
STEAM IRONING
Laundry
Label
Fabric
Temperature
Setting
Soleplate
Temperature
synthetics
e.g. viscose,
polyester
158~248°F
(70~120°C)
silk,
wool
212~320°F
(100~160°C)
cotton,
linen
248~455°F
(140~235°C)
Do not iron / /
NOTE:
– If you need to add water during ironing, UNPLUG
the Power Cord from the outlet and repeat the
above steps.
– Ensure the Steam Iron is fully reheated after filling.
Selecting the Temperature
– Place the Steam Iron on an even and stable surface
on its heel rest.
– Insert the Power Cord into an electric power
socket.
– Adjust the Temperature Dial according to the
international symbol on the garment label (see
chart at left). The Temperature Indicator Light
indicates that the Steam Iron is heating up. Wait
until the Temperature Indicator Light goes off
before ironing.
Selecting the Steam
– The amount of steam is regulated by the Steam
Selector.
– Move the Steam Selector to a position between
minimum and maximum depending on the
quantity of steam required, and the temperature
selected.
WARNING!
During ironing, the Temperature Indicator Light comes on at
intervals, indicating that the selected temperature is
maintained. If you lower the thermostat temperature after
ironing at a high temperature, do not start ironing until the
Temperature Indicator Light turns on again.
WARNING!
The Steam Iron gives off steam continuously only if you hold the
Steam Iron horizontally. You can stop the continuous steam by
placing the Steam Iron in a vertical position or by moving the
Steam Selector to . As indicated on the Temperature Dial you
can only use steam at the highest temperatures. If the selected
temperature is too low, water may drip onto the plate.
NOTE: The Temperature Dial does not adjust the amount of steam.
Also, steam will only work at the specified temperature settings when
set to or