Mueller MLR010002N - Specifications; Year Limited Warranty; Iron Troubleshooting

SPECIFICATIONS | 1110 | IRON TROUBLESHOOTING
Problem Possible Cause Solution
Steam Iron
is leaking
DISTILLED WATER
DO NOT use 100% pure distilled
water, use tap water. In very hard
water areas mix half tap water with
half distilled to reduce hardness;
or use inexpensive bottled spring
water.
Steam Iron
is leaking
SOFTENED WATER
Auto-Off activated?
Overuse of burst
of steam
Most softened water is alright, but
if you experience leaks or spitting,
change to untreated tap water or
inexpensive bottled spring water.
DO NOT use 100% distilled water.
Move Steam Iron or gently shake.
Allow more time between
each burst.
Steam Iron
won’t heat
Is Steam Iron
plugged in?
Temperature
Dial set too low?
Auto-Off activated?
Make sure the plug is in the socket.
Turn Temperature Dial higher.
Move Steam Iron or gently shake.
Temperature
Indicator Light
turns OFF and
ON intermit-
tently
This is normal
The Temperature Indicator Light will
turn from ON to OFF intermittently,
indicating that the selected
temperature is being maintained.
1YEAR LIMITED WARRANTY
This product is warranted to be free from defects in material and workmanship
under normal use and service for one year from the date of the original purchase
with the receipt. The manufacturer’s obligation shall be limited to repairing
or replacing any part of the product that is defective. Such warranty shall
not apply to damages resulting from accidents, abuse, or misuse.
If there is any problem with Mueller
Professional Steam Iron, please contact
Customer Service.
Steam Iron does
not steam
Steam Iron is not hot
enough
Steam valve is
clogged
If the Steam Iron is not hot
enough, the Anti-Drip system will
activate and stop the iron’s steam
production. Set thermostat to
the position. Always allow
sufficient time for the Steam Iron to
heat up (indicator light turns OFF)
before activating the Steam Control
switch.
Move the Steam Selector from
min to max several times to clear
blockage.
Steam Iron does
not steam
The “Burst of Steam”
Button requires
specific settings
“Burst of Steam” function works
when the Steam Selector is
switched to and the Temperature
Dial is set to or .
Continuous steam function only
works when the Temperature
Dial is set to or .
IRON TROUBLESHOOTING
Never iron areas with traces of perspiration or other marks: the heat of the plate
will make the stain “stick” to the fabric, making them irremovable.
To avoid leaving a burn mark on silk, woolen or synthetic garments, iron them
inside out.
Velvet garments can be handled by ironing in one direction (following the fiber).
Do not press down on the Steam Iron.
It is easier to iron fabrics if they are not completely dry. For example, silk should
always be ironed damp.
MUELLERDIRECT.COM
SUPPORTMUELLERDIRECT.COM
8886329981
SPECIFICATIONS
Model Number Voltage Power Soleplate Temperature Cord
MU-77X
120 V
60 Hz
1500 W
158~455°F
(70~235°C)
8 ft
(243.8 cm)