CLEANING | 98 | dRY IRONING
To iron without steam, follow the instructions
in “Steam Ironing” (See Page 6) leaving the
“Burst of Steam” button on position .
Spray Function
Make sure that there is water in the
Water Tank.
Press the “Spray” button down slowly for
a jet or press quickly and firmly for a mist.
– Before cleaning the Steam Iron, make sure that the appliance plug is not
connected to the electric outlet.
– Any deposits or starch residue left on the plate can be removed using
a damp cloth or an unabrasive liquid detergent.
– Avoid scratching the plate with steel wool or metal objects.
– Clean the plastic parts with a damp cloth then wiped over with a dry cloth.
Self-Cleaning Button
The “Self-Cleaning” feature cleans inside the
Soleplate, removing scale and impurities.
We recommend using it every 10–15 days.
– Fill the Water Tank to the maximum level and set
the Steam Control switch to OFF.
– Set the Temperature Dial to the maximum and
wait for the Temperature Indicator Light to turn off.
– Pull the plug out of the socket and hold the Steam
Iron horizontally over the sink.
– Hold the “Self-Cleaning” button until all the boiling
water, steam, impurities and scale come out of
the Soleplate.
BE CAREFUL!
Water might be hot so keep it away from any skin exposed areas.
DRY IRONING
CLEANING
NOTE: Do not use the “Spray” function on silk and synthetics.
Ensure the Steam Iron is fully reheated after filling.
– Make sure the Steam Iron is disconnected from the outlet.
– Let the Steam Iron cool down completely.
– Empty the Water Tank by turning the Steam Iron upside down over the sink,
and gently shaking it.
– Roll up the Power Cord using the “Retract” button.
– Store the Steam Iron, in a vertical position, in a cool and dry place.
STORAGE
Choose “Burst of Steam” Instead of Continuous Steam
When Ironing Vertically
Press the “Burst of Steam” button once to generate
apowerful burst of steam that can penetrate the fabrics
andsmooth the most difficult and tough creases. Wait for
afew seconds before pressing again.
IRONING VERTICALLY: Use the “Burst Of Steam” button
to iron curtains, hanging garments, etc.
WARNING!
The “Burst Of Steam” function can only be used at high
temperatures. Stop the steaming when the plate temperature
control light comes on then start ironing again only after the
light has gone off.
WARNING!
To avoid scald injury, do not touch the heating Soleplate or hot
steam when using the Iron.
ADVICE FOR GOOD IRONING
We recommend using the lowest temperatures with fabrics that have fine finishes
(sequins, embroidery, flush, etc.).
If the fabric is mixed (e.g., 40% cotton 60% synthetics), set the Temperature Dial
to the temperature of the fiber requiring the lower temperature.
If you don’t know the composition of the fabric, test the temperature on a hidden
corner of the garment. Start with a low temperature and increase it gradually until
it reaches the ideal temperature.
To Next Page