Multi-Mover M18 - EC Declaration of Conformity; Compliance with Directives and Standards

MULTI-MOVER M 20
10
EC DECLARATION OF CONFORMITY IIA
(according to Appendix II A of the Machinery Directive)
We, Multi-Mover Europe BV,
Boomsestraat 38, 6613 AH Balgoij, Netherlands
declare at our own full responsibility, that the Multi-Mover M18 with serial number
MM M18
to which this declaration applies, is in conformity with the provisions of the following directive(s):
Applied directive :
2006/42/EC
and is in conformity with the following standard(s) or other standardizing document(s):
EN-ISO 12100 Safety of machinery -- General principles for design -- Risk
assessment and risk reduction.
EN-ISO 14121-2 Safety of machinery -- Risk assessment -- Part 2: Practical guidance
and examples of methods.
EN-ISO 13857 Safety of machinery -- Safety distances to prevent hazard zones being
reached by upper and lower limbs.
EN-953 Safety of machinery - Guards - General requirements for the design
and construction of fixed and movable guards
EN-82079-1 Preparation of instructions for use -- Structuring, content and
presentation -- Part 1: General principles and detailed requirements
EN 60204-1 Safety of machinery - Electrical equipment of machines - Part 1:
General requirements.
EN-IEC 60439-1 Low-voltage switchgear and controlgear assemblies – Part 1: Type-
tested and partially type-tested assemblies.
EN ISO 3864-2 Graphical symbols -- Safety colours and safety signs -- Part 2: Design
principles for product safety labels
Authorized compiler of the technical file :
Netherlands, Balgoij, 18.1.2018 J.J.Offerman
(Country, city and date of issue) (Name and signature or equivalent authentication by
authorized person)