27
www.multilaser.com.br
ENGLISH
3. Battery Management and Charging
. Please make sure that the device battery is fully charged one first usage.
. Just plug the charger into USB interface for charging.
. Keep the first two charging about six 6 hours. And around 4 hours next
time.
[NOTE] This item was featured with built-in polymer battery, the
charger should be comply with the specification of AC110-240V
50/60Hz Max: 180MA. Output: DC5.0-5.5V/1.5A. This item doesn’t
provide DC charging. USB interface can be used for charging.
Choose the charger with USB interface.
. The battery icon will scroll during charging.
. Screen battery icon will turn green and stop scrolling when charging com-
leted.
. To extend the battery life, suggest run out of the power in the first two
times.
[NOTE] If the device is no used for a long time, make sure the
machine will be charged one time within one month, to avoid ex-
cessive consumption.
. On lower power shutdown, plug the charger, the machine tips “ lower
power” and “charging” , the device will enter to the menu if there is enough
power.
. It’s better to charge in standby , otherwise the changing time will be lon-
ger, as the screen consume battery during charging.
nb005_LIVRO_rv1.indb 27 21/3/2012 11:50:30
To Next Page
Loading...
