Multimetrix DMM 107 - Replacing the Battery; Replacing the Fuse; Accessories and Options

32
8. Replacing the Battery
Read the safety guidelines before use. The circuit must
be without power.
Replace the 9 V 6F22 battery when the symbol is displayed:
1. Disconnect the probes.
2. Set the switch to OFF.
3. Remove the 2 screws and the battery lid; replace the 9 V
6F22 battery, being sure to observe battery polarity.
4. Replace the battery lid and the screws.
9. Replacing the Fuse
Read the safety guidelines before use. The circuit must
be without power.
Replace the F 500 mA / 250 V fuse, proceeding as follows:
1. Disconnect the probes.
2. Set the switch to OFF.
3. Remove the 2 screws and the battery lid; replace the fuse
5. Replace the battery lid and the screws.
10. Accessories and Options
Bag of 10 fuses (500 mA) P01297079
Adapter and temperature probe sensor K P06239306
Probes Ø 4 P06239303
Probes Ø 2 P06239302
Detachable probe lighting P06239301