12
Seq. no. Qty. Name Material Dimensions
1 1 Building instructions KIT Paper
1.1 1 Complaints regarding models Paper
2 1 Decal sheet Printed adhesive lm 700 x 1000 mm
3 1 Left fuselage half Foamed Elapor Finished component
4 1 Right fuselage half Foamed Elapor Finished component
5 1 Left fuselage end piece Foamed Elapor Finished component
5.1 1 Right fuselage end piece Foamed Elapor Finished component
6 1 Canopy Foamed EPP Finished component (gray)
7 1 Left elevator unit Foamed Elapor Finished component
8 1 Right elevator unit Foamed Elapor Finished component
9 1 Left wing Foamed Elapor Finished component
10 1 Right wing Foamed Elapor Finished component
11 1 Rudder Foamed Elapor Finished component
12 1 Rudder cover Foamed Elapor Finished component
13 1 Landing skid front + back FunRay Special – adhesive lm Finished component
Seq. no. Qty. Name Material Dimensions
20 2 Mushroom head adhesive tape Plastic 25 x 60 mm
21 2 Velour adhesive tape Plastic 25 x 60 mm
22 2 Locking clip Injected plastic Finished component
23 2 Closure plug Injected plastic Finished component
24 2 Holder for cable ties Plastic 12 x 30 mm
25 1 Fastening strap for battery Plastic 16 x 200 mm
26 5 Rudder horn 'twin' pipe joint Injected plastic Finished component
27 6 Cardan bolt Metal Finished component Ø6 mm
28 6 Hexagon socket set screw Metal M3 x 3 mm
29 1 Hex key Metal WAF 1.5
30 2 Aileron rod with accessories Metal Ø1 x 50 mm
31 2 Camber-changing ap rod with accessories Metal Ø1 x 60 mm
32 1 Elevator rod with accessories Metal Ø1 x 80 mm
33 1 Rudder rod with accessories Metal Ø1 x 85 mm
34 4 Screw (retaining clip) Metal 2.2 x 6.5 mm
35 1 Trim weight (if required) Metal sphere Ø15 mm / 13.8 g
36 4 O-ring (locking clip) Plastic 8 x 2 mm
37 3 Cable tie Plastic 98 x 2.5 mm
38 1 O-ring (elevator unit rudder horn) Plastic 6 x 1 mm
Set of small parts
Parts list KIT FunRay # 21 4334
To Next Page
Loading...
Need help?
General
