How do
you
use
Y-MIX?
a. Activate
Y-MIX with
QUICK-SELECT
Requirement: Y-MIX must not
already be active!
1. Sefect
Y-MIX
menu
point
and activate it
Press
the
-
button, then
E.
The menu
point
is
activated and the
flashing
marker appears
under one ol
the code
numbers 1
to
7.
2.
Select the transmitter controls using QUICK-SELECT
CAUTION: be sure to move the
Slave
lirst.
then the
Masterl
(see
previous page)
Locate
the two transmitter controls
(sticks, pots,
switches) which
you
wish
to
mix,
then
move
them briefly one after
the other.
The
flashing marker
jumps
to the corresponding code
numbers
and
the
flashing
rhythm changes.
lf
you
select the
RUDDER
and AILERON sticks, the
y-tt
X
mixer operates as a combi-switch.
3.
Move
on to adlusting and/or
reversing
the
mixer
input tor
the
Master
Press the E button.
Both
arrows appear at bottom
left in
the display.
This indicates
that travel
for
both sides
is
to be adjusted simultaneously.
Move the control to one
end-ooinl and
hold it
there.
Now use the +/- buttons to adjust the mixer input,
and
watch
the
effecl on vour model.
Tapping
the button
produces
a single step of servo movemenl.
Pressing
and holding the button
produces
a continuous
series
of steps until
you
release the button again. At every step
you
will hear
a
quiet
beep.
lf
you
set the travel lo
zero,
the 07o
marker will have
a dark
background. At 200% every step is accompanied
by
a loud
beeo.
You
can
reverse
the
input with
the
R
button
il necessary.
4. End
the
process,
return
to the Status display
Press
the
E
button once, then
R.
b.) Selecting different trunsmitter controls
for Y-MIX, if
the
mixer
is
already
prcgrammed
You cannot activate
more
than two controls
for Y-MlX.
lf
you
want to
select a new control,
you
should lirst erase the unwanted one.
1. Select lhe menu
point
Y-MIX
and activate
it
Press
the
-
button once
(or
+ five times), then E.
2.
Select the transmitter control and erase
it
Use OUICK-SELECT to select the control
which is
to be erased.
The flashing marker
jumps
to the code
number for
this control.
Now
press
the R button. The flashing rhythm changes, and the
control
is erased.
3. Select the
new
control
Use
QUICK-SELECT
again.
When two controls are active, the
flashing marker
can only be
switched between the two code
numbers.
usino QUICK-SELECT
(or
the +/- buttons).
4. Move on to adiusting and/or reversing the mixer inputs.
Continue as under
point
3. in the
previous
section.
EB
E/8...
',)
"')
0./.:
o)
@,
?00"/"
EI
trI
,
.D)
EB
@
tr
€
GB-19- Manual EUROPA mc
To Next Page
Loading...
Need help?
General
