Need help?Do you have a question about the Multiplex MULTInaut top and is the answer not in the manual?
General| Brand | Multiplex |
|---|---|
| Model | MULTInaut top |
| Category | Remote Control |
| Language | English |
Highlights unique features such as QUICK-SELECT and Diagnosis operation.
Explains the transmitter's status display, including battery level and model memory indication.
Details how transmitter stick movements correlate to servo movements and channel assignments.
Troubleshooting steps for common issues like no response, incorrect direction, or range problems.
Explains the correlation between stick movements and control surface functions (modes).
Provides instructions on how to reverse servo direction if control surfaces move incorrectly.
Illustrates setting up a twin-motor boat using mixers for coordinated rudder and motor control.
Step-by-step guide to activate and configure the X-MIX function for cross-mixing signals.
Instructions for activating and configuring the Y-MIX function for mixing signals to a single servo.
Explains the SERVO menu for adjusting travel, centre, and direction, and outlines the process flow.
Detailed steps for adjusting servo centre position and travel range using transmitter controls.
Guides on setting Dual Rate travel amounts, applying to both sides equally via the DR MN menu.
Instructions on how to erase a model memory, restoring factory default settings.
Guides on selecting controls for X-MIX, covering initial activation and subsequent modifications.
Detailed steps for activating X-MIX for the first time, including control selection and input adjustment.
Guides on activating Y-MIX using Quick-Select, mixing controls for Master and Slave.
Critical safety guidelines for the MULTInaut system, including current limits and air circulation.
Guides for EUROPA mc nautic users and for expanding other models with MULTInaut Top.
Steps for connecting the MULTInaut transmitter module, including plug orientation and activation.
Procedure to activate the MULTInaut system via the DR MN menu after module installation.
Guides on assigning transmitter sticks and controls to receiver outputs based on possibilities.
Recommends using a trainer-pupil setup for learning, detailing cable requirements and setup.
Highlights differences in stick assignments for the EUROPA mc 1005 compared to other models.
Details a procedure for performing range tests to ensure safe operation of the model.
To Next Page