REGULATORY & SAFETY INFORMATION
Conduit
®
Cat 4 for North America MTCDT-L4N1 Hardware Guide 29
The antenna of this transmitter must provide a separation distance of at least 20 cm from all persons. Installers
and end-users must be provided with antenna installation instructions and transmitter operating conditions and
instructions for satisfying RF exposure compliance.
The final product operating with this transmitter must include operating instructions and antenna installation
instructions, for end-users and installers to satisfy RF exposure compliance requirements.
The maximum antenna gain including cable loss for compliance with radiated power limits, RF exposure
requirements and the categorical exclusion requirements of 2.1091 is 5.63 dBi for 600 MHz bands, 5.94 dBi for the
700 MHz bands, 6.12 dBi for the 800 MHz bands, 5.00 dBi for the 1700 MHz bands and 8.01 dBi for 1800 MHzband.
Multi-transmitter, supporting simultaneous transmission configurations, have not been evaluated and shall be
evaluated according to KDB Publication 447498 and §2.947(f) composite system and §2.1 end product terms and
concepts.
Compliance of this device in all final product configurations is the responsibility of the Grantee.
Installation of this device into specific final products may require the submission of a Class II permissive change
application containing data pertinent to RF Exposure, emissions and host/module authentication, or new
application if appropriate.
This device contains functions that are not operational in U.S. Territories. This filing is only applicable for U.S.
operations.
Industry Canada Class B Notice
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Reglement Canadien sur le matériel
brouilleur.
This device complies with Industry Canada license-exempt RSS standard(s). The operation is permitted for the
following two conditions:
1. the device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Lithium Battery
A lithium battery (3V, coin cell, CR1632) located within the product provides backup power for the
timekeeping. If the device is left powered off, the battery lasts approximately 90 days.
When this battery starts to weaken, the date and time may be incorrect.
Battery is not user replaceable. If the battery fails, the device must be sent back to MultiTech Systems for
battery replacement.
To Next Page
Loading...