Munchkin Float - How to Disassemble; Disassembling Footrest, Seat, and Brackets; Disassembling Legs from Leg Bridges

How to Disassemble How to Disassemble
11
How to Assemble
DISASSEMBLING THE LEGS
FROM LEG BRIDGES
NOTE: For the following steps, you will need
a pen or allen wrench (tool not included).
Insert the tool into the pinhole on the inside of
the leg bridge to depress the snap connector.
Pull out the leg from the bridge. Repeat on
each side for all four legs.
DISASSEMBLING THE FOOTREST,
SEAT, AND SEAT BRACKETS
1. Push the footrest release buttons, then
slide the footrest off.
2. Push the release levers on the underside
of the tray and pull out.
3. Press the snap connectors to release the
seat, brackets, and legs.
Snap
Connector
Snap
Connector