Need help?Do you have a question about the Munters Farm Premium XL and is the answer not in the manual?
General| Display | 7 inch touch screen |
|---|---|
| Power Supply | 24 VDC |
| Operating Temperature | 50 °C |
| Humidity Range | 0 - 95% RH |
| Outputs | analog outputs |
| Inputs | Analog and digital inputs |
Sets temperature targets according to bird/pig age.
Overview of controlling humidity, CO2, and ammonia levels.
Increases ventilation when humidity is too high.
Increases ventilation when CO2 level is too high.
Selects range of ventilation levels based on situation.
Sets static pressure targets and alarms.
Increases ventilation when ammonia level is too high.
Sets up to 30 ventilation levels controlling fans.
Settings for optional emergency cards.
Uses wind to supply house air requirements.
Defines various alarm settings.
Displays identified switches and relays to find faulty hardware.
Checks installed hardware identified by Plug and Play.
Calibrates temperature sensors by adjusting a correction factor.
Calibrates humidity level using a test kit.
Calibrates CO2 level using a test kit.
Calibrates the static pressure sensor.
Calibrates the light sensor.
Calibrates digital monitoring devices for feed.
Enters quantity of water per pulse for water meters.
Calibrates the ventilation potentiometer control.
Calibrates the amount of current passing through Current Sense relays.
Calibrates a wind direction sensor.
Calibrates the Water on Demand (WOD) sensor.
Calibrates the ammonia level sensor.
Configures critical parameters like units, language, and modes.
Defines devices connected to the controller by mapping relays.
Installs and configures analog sensors like temperature, humidity, CO2.
Configures installed digital sensors for water and feed consumption.
Controls devices like fans, heaters, dimmers, vents, curtains via analog output.
Defines ventilation opening/closing mechanism using time, potentiometer, or wind.
To Next Page
