Need help?Do you have a question about the Munters Rotem RBU-27 SE and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Manufacturer | Munters |
| Model | Rotem RBU-27 SE |
| Relative Humidity | 10% to 90% non-condensing |
| Enclosure Rating | IP65 |
| Ambient Temperature | -20°C to +50°C |
| Communication | RS-485 |
| Display | LCD |
| Digital Inputs | 4 |
Provides general information on the document's purpose and content scope.
Explains symbols and terms used in the manual for clarity and safety.
Lists contact details for support and further information.
Details the controller front panel and available switch functions like Inlet/Tunnel and Latch On/Off.
Lists core RBU-27 SE functions: air sources, weather protection, fail-safe modes.
Lists critical safety warnings and recommendations for device installation.
Provides steps and considerations for physically installing the RBU-27 SE unit.
Specific notes and connections required for integrating with Platinum Controllers.
Explains electrical connections and wiring diagrams for RBU-27 SE setup.
Instructions for drilling holes in the unit for cable routing during installation.
Covers common problems related to power, circuit breakers, and general connections.
Details troubleshooting for contactors and terminal connections within the unit.
Procedure for testing internal relay contacts using an ohmmeter.
Guidelines for selecting, installing, and using ground rods for effective grounding.
Information on material, size, and installation of ground wires.
Explains the use of ground clamps for attaching ground wires to ground rods.
Identifies equipment and circuits that require grounding for safety and protection.
To Next Page
