Section 30 00-02-0977
2018-02-23 - 3 -
Installation
Preparing the Enclosed Panel
Determine the location of the TEC-10 Panel on the customer-
supplied mounting bracket or plate. The suitability of the location
is subject to investigation by the local authority having jurisdiction
at the time of the installation.
Recommended torque for tightening both the shockmounts into
the panel and the nuts on the shockmounts is 78 inch-pounds or
8.8 Nm (Newton Meters). Although thread lock is not required,
only blue polycarbonate compatible thread lock should be used
for the TEC-10 mounting screws.
To Next Page
Loading...
Need help?
General
