00-02-0796 - 34 - 08-26-11
Auxiliary Gage Fault
Murphy PVA Gages can be attached to the PowerView. If
an auxiliary gage should fail, the 1-up or 4-up display will be
replaced with a fault message: GAGE NOT RESPONDING.
NOTE: A fault can only be cleared by correcting the cause
of the condition (See Troubleshooting in this document).
Active Fault Codes
When the PowerView receives a fault code from an engine,
the 1-up or 4-up display is replaced with the active fault
codes message. See following fault example:
To Next Page
Loading...
