Murphy PowerView PV-101-A User Manual

10-18-11 00-02-0795
Section 78
PowerView
Model PV-101-A, V2.3
User’s Guide

Murphy PowerView PV-101-A Specifications

General

Brand	Murphy
Model	PowerView PV-101-A
Category	Monitor
Language	English

Summary

Engine and Transmission Parameters

PowerView Faceplate Features

Navigation and Keypad Functions

Operation and First-Time Startup

Display Setup Options

1-Up Display Setup

Configure the display for a single parameter, with options for defaults, custom setup, or automatic scanning.

4-Up Display Setup

Configure the display for four parameters in quadrants, including defaults and custom setup.

Main Menu Options Overview

Stored Fault Codes

Access and display stored fault codes from the engine ECU.

Service Reminders

Modbus Setup Configuration

Modbus Serial Port Configuration

Configure serial port parameters like Baud Rate, Parity, Data Bits, and Stop Bits for Modbus slave applications.

Select Engine ECU

OEM Menu and Advanced Configuration

Accessing the OEM Menu

Procedure for entering the password to access the OEM menu.

OEM Modbus Setup

Configure Modbus settings like port, address, and active modes within the OEM menu.

OEM Engine ECU Selection

Set Source Address

Configure the source claim address for the PowerView on the CAN Network.

Restore All Defaults

Faults and Warnings Indicators

Visual Indication (LEDs)

Fault Indicators on Display

Auxiliary Gage Fault Handling

Active Fault Codes

Derate / Shutdown Codes

Display of severe fault codes triggering derate or shutdown messages.

Acknowledging Fault Codes

Procedure to acknowledge, hide, and redisplay faults on the PowerView.

Troubleshooting Common Messages

WAIT TO START PREHEATING Message

CANBUS FAILURE Message

TIMEOUT ECU NOT RESPONDING Message

Occurs when ECU does not respond to requests for Stored Fault Code information.

Parameter Value Messages