00-02-0795 - 23 - 10-18-11
Modbus Setup
1. From the UTILITIES menu, select MODBUS
SETUP.
2. Select either the SLAVE ACTIVE (SCADA or
remote Modbus master) or MASTER ACTIVE
(auxiliary gages) modes. Touch Enter to toggle
between master and slave.
3. Select SERIAL PORT SETUP (slave mode only),
then touch Enter.
4. Continue to scroll each selection (BAUD RATE,
PARITY, DATA BITS, and STOP BITS) to configure
the serial port parameters for your Modbus slave
application.
Fault Conversion
View and/or edit the J1939 fault code conversion method.
NOTE: There are four (4) different methods for converting
To Next Page
Loading...
