00-02-0796 - 38 - 08-26-11
NO STORED CODES is displayed
The PowerView sent a request to the ECU for Stored Fault
Code (DM2) information. The ECU responded: There are
zero stored codes.
NO GAGE DATA is displayed
The PowerView has no record of gages connected to the
RS485 bus.
NO DATA is displayed in place of a parameter value
The PowerView has not received data for the selected
parameter for at least 5 seconds.
NOT SUPPORTED is displayed in place of a parameter
value
This means the data received for this parameter is not valid
or not supported.
To Next Page
Loading...
