10
OPERATING INSTRUCTIONS
Quick Setup Guide
This Mower is fitted with a Motor THERMAL PROTECTION* device to protect
the motor in case it shuts down during operation due to overloading or
blockage.
Avoid frequently over-loading the mower as this may turn on the Motor Thermal
Protection. The Motor Thermal Protection will require the machine to be rested
sufficiently to cool. Clean the blockage and restart by raising cut height.
1 - READY
• Remove plug from the main power supply
• Check if the grass is tall or thick
• Check catcher & deck are empty of grass
Don't adjust the mower without switching off and
unplugging the device.
Switch off and remove the plug from the main power
supply before adjusting the mower.
Don't cut when catcher is full or if chute is blocked.
Empty catcher prior to mowing.
2 - SET
• Increase cut height in tall or heavy grass
• Clean the catcher & deck of cut grass
• Push the mower slower in heavy grass
Don't cut low in long, thick or wet grass.
Adjust to cut higher in overgrown lawn.
Don't force mower through thick lawn.
Slow down if grass becomes thicker.
Don't continue cutting if mower frequently cuts out.
Avoid frequent THERMAL PROTECTION cutouts.
Don't continue if motor over heats.
Allow the motor to cool if the Motor THERMAL
PROTECTION is activated.
3 - GO
• Insert plug in the main power supply.
• Try cutting grass at selected height
• Increase height & cut grass more frequently as
required in long heavy grass
• If THERMAL PROTECTION* stops the mower,
release the lever and remove the plug from the main
power supply
• When mowing if catcher indicator flap is down,
catcher is full.
To Next Page
Loading...
