C
H
O
K
E
17
Problem Possible Cause Correction
Does not start.
The mower is not connected to
power supply.
Connect to the power supply.
Grass is too long, wrapped around
the blade.
Start on short grass or increase the
cutting height.
Mower housing clogged with grass
and debris.
Check under the deck for clogged
grass and clean discharge channel.
Loss of power.
Cutting too much grass. Increase the cutting height.
Mower housing clogged with grass
and debris.
Check under the deck for clogged
grass and clean discharge channel.
Cutting blade worn or rusty. Replace the cutting blades.
Grass box is full. Ensure the grass box is empty.
The mower cuts the grass
unevenly.
The lawn is rough or uneven. Check the mowing area.
The cutting height is not set properly. Increase cutting height.
The mower does not mulch
properly.
Wet grass clippings are sticking to the
underside of the deck.
Wait until the grass dries before
mowing.
The mulch plug is missing. Install the mulch plug.
The mower is hard to push.
The grass is too tall, or the cutting
height is too low.
Raise the cutting height.
The rear of the mower housing and
the blade are dragging in thick grass.
Empty the grass clippings from the
grass catcher.
The mower is excessively noisy
and vibrates.
The motor shaft is bent. Stop the motor, and inspect for
damage.
The blade is unbalanced. Repair before restarting. If vibration
persists, contact authorized service
centre.
The mower cuts out (”stalls”)
when cutting grass.
The mower blade is overloaded due
to mowing conditions, e.g. long,
thick, moist grass or the grass type.
Stop the motor , increase the cutting
height and try to cut again.
Wait for the grass to dry and attempt
mowing again.
Blades restricted by grass and dirt
accumulated under the baseplate.
Check under the deck for clogged
grass and clean discharge channel.
The grass catcher is not filled
sufficiently.
The lawn is too wet. Wait until the grass dries before
mowing.
Mower housing clogged with grass
and debris.
Check under the deck for clogged
grass and clean discharge channel.
Cutting blade worn or rusty. Replace the cutting blades.
Grass box is full. Ensure the grass box is empty.
TROUBLESHOOTING
Troubleshooting
To Next Page
Loading...
