2. 7.5 Click on the Wifi network name of the water heater, it will skip to server validation
interface after enter WLAN network name and password of the connected internet.
And next skip to user login interface after successful validation. If connect with WIFI
is not successful, repeat step 2.7.3~2.7.5, and try again.
Enter correct WLAN network name
Enter the password
Click on “Confirm”
2. 7.6 For IOS, after chosing AP mode, it will appear below interface, then back to setting
interface on the phone, and select the WIFI signal on controller. Then enter WIFI
password at your home and then confirm, WIFI will automatic configurated well.
To Next Page
Loading...