EN-8
Audio Streaming
1. If your phone is “A2DP” format is compatible, you can play music in your mobile and the music will be transferred to
car audio unit.
2. Make sure your mobile and the car radio unit is paired and connected.
3. Play the music in your mobile according to your mobile operating method.
4. Unit will display “A2DP” when receiving A2DP music automatically, but for some mobile your have to press
LD/MOD
button to change A2DP mode.
5. You can press
or on head unit for previous or next tracks.
RESET
Reset button is placed on the housing.
The reset button is to be activated for the following reason:
• Initial installation of the unit when all wiring is completed.
• All the function button do not operate.
• Error symbol on the display.
TECHNICAL SPECIFICATIONS
CD/MP3/WMA PLAYER SECTION
Signal to Noise Ratio > 60 dB
Channel Separation > 50 dB (1kHz)
Frequency Response 20Hz - 20 kHz
TUNER (FM)
Frequency Range 87.5-108 MHz
Channel Step 50 kHz
Intermediate Frequency 150 KHz
Sensitivity 2.8 µV
Stereo Separation 37 dB
Signal to Noise Ratio > 50 dB
TUNER (MW)AM
Frequency Range 522-1620 KHz
Intermediate Frequency 25 KHz
Usable Sensitivity 32 dB
LINE-OUT
Output 1.5V (max.)
Impedance 10k Ohm
GENERAL
Power Supply 12V DC (10.8-15.6V allowable)
Speaker Impedance 4 or 8 ohm
Output Power 50W x 4CH
Fuse 10A
Note: Specications and the design are subject to possible modication without notice due to improvement.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2002/96/EC in order to
be recycled or dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the
environment and human heath due to the presence of hazardous substances.
To Next Page
Loading...