Daily Maintenance Sheet for XPJ-461UF
Daily maintenance
b
c
e
f
a
g h
d
i
j
k l
CS3014-00 -1-
Preparation:
Wear the polyethylene gloves (white) over the
plastic gloves (pink).
Wear personal protective equipment such as
goggles, protective mask or clothing.
Important!
Before performing maintenance, make sure to read
“How to handle UV inkjet printer / its supplies”
(supplied with the printer).
Skin or eye contact with UV curable ink may cause skin
inammation or allergic reaction.
When using this product, wear personal protective
equipment (supplied gloves or solventresistant gloves,
goggles or protective eyewear, protective mask,
CAUTION
Tap on the front panel.
Use to choose “Menu 5: Sleep Mode”.
Tap .
When [Sleep Mode1 Start] appears, tap .
When [Sleep Mode Start Enter] appears, tap .
When [Daily Maintenance Start Enter] appears, tap .
When [Unload Media then Tap Enter] appears, remove the media and the jig on the table,
and then tap .
When [Daily Maintenance End Enter] appears, you can start the maintenance with
following steps.
Make sure to complete this maintenance within 5 minutes while the printer is in Daily maintenance state.
The content of this documents are based on the specication of the rmware Ver.1.00 or later.
++
When to maintain:
After operation (Be sure to perform the following maintenance)
When the media strikes the print head
Required Items:
(a) Polyethylene gloves (Supplied accessories or
Commercial item)
(b) Rubber gloves (Supplied accessories or
Commercial item)
(c) Protective goggles (Supplied accessories)
(d) Paper towel (Supplied accessories)
or Polyester knit wiper (Optional accessories)
(e) Dropper (Supplied accessories)
(f) Dedicated maintenance cleaner (Optional
accessories)
(g) Plastic cup (Supplied accessories)
(h) Cleaning stick (Supplied accessories or Optional
accessories)
(i) Tray (Supplied accessories)
(j) Scraper (Supplied accessories)
(k) Protective mask (Commercial item)
(l) Protective clothing (Commercial item)
Use a paper towel supplied with the printer or optional
Polyester knit wiper. DO NOT use a tissue.
Lints or akes on tissue may cause damage to the print head.
DO NOT use non-dedicated maintenance cleaner.