MVP SPRINT - Calibration and Testing Procedure

Page 2 OF 2
3/32” or 2.5mm hex
wrench, or smaller
Calibrate and test the moon
1. Press the power buon so it turns blue. Turn on the transmier (side switch
up). Use the hex wrench to push the calibraon buon (Cal buon is le-most
1/8" hole ) unl both red and green LEDs ash.
2. Pull the transmier trigger AND turn the direcon
knob SIMULTANEOUSLY back and forth to their limits
unl the LEDs show red only.
7. Turn o both the base and the transmier.
Cover the calibraon hole. Install plugs in
both 1/8" holes
4. Verify that the LEDS go red only, then green only.
3. Verify that both red and green LEDs ash.
5. Test the wheels. Pull the trigger to make
both go forward. Push the trigger to make
both go backward.
6. Test the wheels. Turn the direcon knob
clockwise to make the le go forward and
the right backward. Turn it counterclockwise
to make the wheels do the opposite.
Do not touch the transmitter while the
lights continue flashing. Wait 10 seconds
before testing the transmitter.