My Fireplace Blower FK12 User Manual

Installation Videos:
MY
FireplaceBlower
MyFireplaceBlower.com:
Installation Instructions:
Installer is responsible to check local codes
and read all instructions prior to installation.
Layout designed in U.S.A. © 2014
My Fireplace Blower
Burlington, Wisconsin
1-800-466-4045
Drywall dust or other fragments may be present in your replace’s vent space, clean this area before you install the
blower kit. Any bearing or motor damage resulting from this condition is not covered by the warranty policy.
Instructions for Design Version - FK12 Blower Kit
This Blower Kit is tested and safe when installed in accordance with these installation instructions. It is your re-
sponsibility to read all instructions and consult the Owner’s Installation Manual for your particular model number
for Supplemental Information before starting installation. Blower operates on 115V/60Hz power.
CLICK
High Quality Aftermarket Fireplace Blowers & Fans
1-800-466-4045
Check the contents of the carton.
Make sure nothing was damaged in shipment.
Do NOT install a damaged blower kit!
Blower Kit Parts
Step 1: Turn Off Fireplace and allow it to cool
down. Disconnect from 120V Power. Shut off
the Gas supply. Remove the louver which cov-
ers the lower vent space below the rebox.
Lay cord set out in a straight line, with the
3-Prong Power Plug furthest away from the
replace.
Step 2: Push the green wire disconnect onto the
ground tab on the end of fan. (Figure: 1)
Connect white and black wires of the cord set to either
of the spade terminals attached to the motor. Push
disconnects onto metal tabs. (Figure: 1)
CLICK
CLICK
NOTE: Diagrams and Illustrations NOT to Scale
Page 1 of 4
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK!
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE INSTALLING BLOWER!
When installed, make sure to contain any excess wire of the cord set;
Preventing it from making contact with moving or hot objects.
Description
Qty.
Fan
Power Cord
Velcro Strip
Dampening Pad
1
1
1
3
1
Installation Instructions (Downloadable)
Figure: 1
•Does not matter which metal tab you
connect the black and white wires to.

My Fireplace Blower FK12 Specifications

General

Brand	My Fireplace Blower
Model	FK12
Category	Blower
Language	English

Summary

Safety Warnings and Precautions

General Warning

Risk of fire and electrical shock. Turn off gas and electrical power before installation.

Wire Management

Contain excess wire to prevent contact with moving or hot objects.

Environmental Hazards

Clean vent space of dust/fragments; motor damage from this is not covered by warranty.

Blower Kit Components and Preparation

Check Kit Contents

Verify all parts are present and undamaged before installation.

Initial Power Disconnection

Turn off fireplace, disconnect 120V power, and shut off gas supply.

Installation Steps

Step 1: Power Down and Vent Access

Turn off power, gas, remove louver, lay out cord set.

Step 2: Connect Fan Wiring

Connect green wire to ground tab and black/white wires to motor terminals.

Step 3: Mount Fan Assembly

Wipe mounting area, attach fan with velcro, position for air exit.

Step 4: Access Fireplace Interior

Remove refractory brick and access panel for easier installation.

Step 5: Connect to Power and Finalize

Plug into junction box, check wiring, restore power, test operation.

Wiring and Finishing

Wiring Diagram

Illustration of how to connect the blower kit wires to the fireplace junction box.

Final Checks and Reassembly

Restore gas and power, test fan operation, then reinstall panels.