- 28 -
The Boundary Flags are visual reminders for
your pet, teaching them where the Warning
Zone is located. Hold the Receiver Collar at
your pet’s neck height and slowly walk
towards to the Warning Zone until the
Receiver Collar beeps. Immediately when you
hear the beep, place a Warning Flag in the
ground and then walk back into the Pet Area
until the beeping stops. Repeat this process
around the Warning Zone until it is marked
with Boundary Flags approximately every 10
feet.
VIII. Fit the Receiver Collar:
Now that you’ve set the Boundary Area, it’s
time to fit your dog with his collar. Begin by
placing the collar strap in the middle of your
dog’s neck. The receiver should be on the
underside of his neck; however, on some dogs
the receiver will naturally seek a slightly
off-center position. The Rubber Cover should
To Next Page
Loading...