EasyManua.ls Logo

MY PROJECT MPMAP 12000 C3 - Troubleshooting; Cleaning Instructions

MY PROJECT MPMAP 12000 C3
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
GB
z Troubleshooting
= problem
= cause
= remedy
The portable jump starter with power bank
1
is
not fully charged, even though all 4 indicator
lights
8
are permanently lit.
It is 60% charged after a long period out of use or in storage.
Charge the portable jump starter with power bank
1
again
as described in the section: “Charge portable jump starter
with power bank”.
There is no response to pressing the power button
7
.
The undervoltage protection circuit for the portable jump
starter with power bank
1
is activated.
Charge the portable jump starter with power bank
1
again
as described in the section: “Charge portable jump starter
with power bank”.
One indicator light
8
flashes, however the portable
jump starter with power bank
1
cannot be used.
The undervoltage protection circuit for the portable jump
starter with power bank
1
is activated.
Charge the portable jump starter with power bank
1
again
as described in the section: “Charge portable jump starter
with power bank”.
z Cleaning
The device must not come into contact
with water or be placed in water. There is a risk of
injury due to electric shock if moisture enters the device.
Do not use cleaners or solvents. These could damage the
device beyond repair.
Keep the housing and device accessories clean.
Use a damp cloth or a soft brush to clean the device and the
accessories.

Table of Contents