MY PROJECT MPMAP 12000 C3 - Charge Jump Starter; Jumpstart Feature Operation

42
GB
z Charge portable jump starter with
power bank
 Connect the 3-way USB cable
16
with the charging port
(USB-C)
4
and an appropriate USB-A socket or an
appropriate USB network adapter (working output voltage
U
out,max
5 V ).
PLEASE NOTE: USB network adapter not included in the
scope of delivery.
PLEASE NOTE: An undervoltage protection circuit is
installed in the portable jump starter with power bank
1
to
protect the device from damage. This prevents a deep discharge
of the portable jump starter with power bank
1
and automati-
cally switches the device off once the rechargeable battery pack
is fully discharged. Shortly before the undervoltage protection
circuit is activated, the last blue indicator light
8
will start to
flash. As soon as the undervoltage protection circuit is activated,
the last blue indicator light
8
flashes and power will no longer
be delivered. Please charge the portable jump starter with power
bank
1
again.
z Using the jumpstart feature
Step LEDs Meaning / Error Solution
1. Connect the
jump lead
10
of
the portable
jump starter with
power bank...
Red Error LED
13
is continuously lit
on the jump lead
10
.
The voltage
determined in
the portable
jump starter with
power bank
1
is not enough to
start the car.
Charge the
portable jump
starter with
power bank
1
.
... to the
jumpstart outlet
9
of the mobile
jump starter with
power bank
1
.
Green Start LED
12
and the red
Error LED
13
flash alternately.
The portable
jump starter with
power bank
1
is ready.
Carry on with
step 2.