MY PROJECT MPMAP 12000 C3 - Lighting Modes

44
GB
As soon as the vehicle starts, remove the jump
lead
10
from the portable jump starter with power bank
1
within
30 seconds and disconnect firstly the black battery clamp and
then the red clamp from the battery poles. Otherwise, it could
result in dangerous situations! Leave the vehicle engine running.
PLEASE NOTE: The button on the LED box
11
of the jump
lead has no effect and must not be used. It is only used for
troubleshooting purposes during the manufacture of the device.
z Charging mobile phones and tablets
 Press the power switch
7
.
 Connect your mobile phone or tablet’s USB power cable to
the USB output (5 V /1 A
5
/2 A
6
) and then to your
mobile phone or tablet.
PLEASE NOTE: Charging is not possible if the portable
jump starter
1
with power bank is being charged itself.
z Using the 12 V DC output 8 A with
cigarette lighter adapter
 Press the power switch
7
.
 Connect the 12 V/8 A cigarette lighter adapter
14
on the
12V DC output 8 A
3
to your portable jump starter with
power bank
1
und then connect it to your terminal device.
PLEASE NOTE: You will not be able to use the portable
jump starter with power bank
1
if it is being charged.
ATTENTION: Only use the 12 V/8 A cigarette lighter
adapter delivered with your product
14
. There is a risk of a short
circuit if you use third-party adapters.
z Switch on lighting
Light mode
 To turn on the LED lamp
2
, push the activation button for the
LED lamp
2a
.