To Next Page
A
Anthony SmithAug 9, 2025
How to fix poor cutting on MyBinding Cutter?
- JjenniferyoungAug 9, 2025
If you're experiencing poor cutting quality with your MyBinding Cutter, the cutting blade likely needs sharpening or replacement.
How to fix poor cutting on MyBinding Cutter?
If you're experiencing poor cutting quality with your MyBinding Cutter, the cutting blade likely needs sharpening or replacement.
Why is the display illumination off on my MyBinding Cutter?
The display illumination might be off on your MyBinding Cutter due to power supply issues. Ensure the mains switch is on, the mains plug is properly plugged in, the main fuse is functional, and the overload switch is also on.
What to do if cutting may not be activated on MyBinding Cutter?
If the cutting function isn't activating on your MyBinding Cutter, try these steps: If the dimension wasn't approached correctly, press the button again. Open and close the guard to ensure the safety check is cleared. If the measurement is below 9.00 cm, press until the backgauge reaches the correct position. If none of these solutions work, the backgauge may not be in the correct position, and you should inform the technical service.
What to do if the last sheet of paper in a stack is not completely cut by MyBinding Cutter?
To resolve this issue, set the cutting depth or turn/replace the cutting stick.
Details the machine's design for cutting paper reams to specified dimensions using a two-handed control system.
Information on the machine's nameplate, required voltage, frequency, and earth wire connection.
Identifies and explains the function of all control panel buttons and machine components.
Steps to start the machine, including safety guard operation and backgauge reference position search.
Guide to entering dimensions via keypad, approaching them with Start key, and handling small dimensions.
Procedure for activating the cut using the two-hand control system after closing the guard.
Overview of storing 9 programs, each with 9 steps, and unit conversion capabilities.
Instructions for adjusting cutting depth, turning, or replacing the cutting stick for optimal cuts.
Procedure for replacing the blade when cut quality is poor, including safe demounting and mounting.
Lists malfunctions like non-activation, display errors, and incomplete cuts with causes and remedies.
General
