To Next Page
K
Kevin MooreJul 31, 2025
What to do if MyBinding Cutter rejects paper?
- SShelia MontesJul 31, 2025
If your MyBinding Cutter is rejecting paper, there are several possible causes and solutions: * If the paper is stuck inside the machine, remove it. * If the issue is with the PPS (likely referring to a paper positioning system), try to finish the current operation. * Check the Main PWB unit. Ensure that the connector is firmly plugged in. * Clean the relevant sensors. If cleaning doesn't resolve the issue, replace the sensors. * If a faulty sensor is the cause, replace it.
General
