MyBinding DC-545HC - Removing the Feed Solenoid; Removing the Gate Solenoid (Without Using the DC 545 HC)

89
!1 Remove the E rings from the 4th roller (upper).
(2 positions)
!2 Remove the 4th roller (upper).
!3 Take out the 4 screws, and remove the center plate.
!4 Take out the 2 screws, and remove the PPS3
phototransistor.
Ref. Photodiode: Brown, blue
Phototransistor: white, blue
(7) Removing the Feed Solenoid
q Remove the cover R unit from the DC-545.
\See page 49
w Remove the connector for the solenoid. (1 position)
e Take out the screw, and remove the Z collar.
r Take out the 2 screws, and remove the bracket.
t Take out the 3 screws, and remove the feed solenoid.
(8) Removing the Gate Solenoid (Without
using the DC-545HC)
q Remove the cover L unit from the DC-545.
\See page 50
w Remove the connector for the solenoid. (1 position)
e Take out the 2 screws, and remove the bridge.
r Take out the screw, and remove the Z collar.
t Take out the 2 screws, and remove the bracket.
y Take out the 3 screws, and remove the feed solenoid.
Plate
Screws
Center Plate PPS3 Phototransistor
Bracket
Z Collar & Screw
Connector
Bridge
Bracket
& Screws
Z Collar & Screw
. Electric Section
Chap.3