MyBinding DC-545HC - Functions and Operation Procedures for each HELP Mode; Accessing HELP Mode

141
x Functions and operation procedures for each HELP mode
x Functions and operation procedures for each HELP
mode
(1) Accessing HELP mode
1) When the machine is in use, put it in standby and then turn “OFF” the power switch.
2) Turn the power switch “ON” while pressing the <Stop> key. The “HELP mode” is displayed.
3) Select the “HELP mode no.” setting that you want to change by pressing the <+> key and the <-> key.
4) Press the <Start> key.
Enter the “HELP mode” that you selected in Step 3.
Follow the procedure for each of the various “HELP modes” described below.
Chap.7