2205Q2JE-HO-S6-N_2020.01.
Chapter 5 Maintenance and Inspection
SCV-series Screw Compressor 5.2 Maintenance and Inspection List
5-6
5.2.3 Guidelines for Compressor Overhaul Frequency
When servicing or overhauling the compressor, follow the instructions and guidelines described below.
The compressor inspection frequency significantly differs depending on the operating conditions,
refrigerant in use, type and condition of lubricant, and the system in which the compressor is operated.
The table below indicates the overhaul frequency recommended by
based on the
operating conditions of the compressor.
Table 5-4 Standard Package Operaion Conditions and Overhaul Frequency Guidelines
Conditions of use Example application Guideline for the overhaul timing
Relatively stable operating conditions
Cold storage and
Every 5 years or 40,000 operating
Relatively changing operating condition Ice maker/Chiller
Every 4 years or 30,000 operating
Frequent started/stoped, and relatively
changing operating conditions
Heat pump
Every 3 years or 20,000 operating
hours
Note 1: The above guidelines are only applicable when the compressor is operated within the
operation limits which are specified separately. (See Chapter 2, Section 2.3.2 "Operation
Limits" in this manual.)
Note 2: The above guidelines are only applicable when the compressor undergoes daily and
periodical inspections specified separately. (See 5.2.1 "Daily Management" in this manual.)
Note 3: Inspect the compressor at the intervals ofspecified period or operating hours, whichever
comes first.
Note 4: The above guidelines do not constitute any warranty.
To Next Page
Loading...
Need help?
General
