Myenergi Hub User Manual (English)

To Next Page

Setting up a new

myenergi hub

When you are setting up a new myenergi hub, there are a few steps

that you will need to follow to make sure that everything is up to

date.

1. Make sure that the new hub has the latest ﬁrmware installed

before

2. Pair! the new hub with your eddi and/or zappi

Setting up a new myenergi hub

Please follow the instructions below.! If you run into any problems

please contact our technical support team at

support@myenergi.com.au

(1) Plug the hub into the power and

Ethernet

Once the hub is plugged in you should see a green “power” light

and a blue “server” light

Need help?

Do you have a question about the Myenergi Hub and is the answer not in the manual?

Myenergi Hub Specifications

General

Steps to plug the myenergi hub into a power source and connect it via Ethernet to your router.

Instructions for pairing the myenergi hub with an Eddi device to enable communication.

Detailed guide for pairing the myenergi hub with the Zappi v1 model.

Detailed guide for pairing the myenergi hub with the Zappi v2 model.