To Next PageTo Next Page
Need help?Do you have a question about the Myron L ULTRAPEN PT2 and is the answer not in the manual?
General| Measurement Parameters | pH, ORP, Conductivity, TDS, Temperature |
|---|---|
| pH Range | 0.00 to 14.00 pH |
| pH Resolution | 0.01 pH |
| pH Accuracy | ±0.02 pH |
| ORP Range | ±999 mV |
| ORP Resolution | 1 mV |
| ORP Accuracy | ±1 mV |
| Temperature Resolution | 0.1 °C |
| Temperature Accuracy | ±0.5 °C |
| Automatic Temperature Compensation | Yes |
| Display | LCD |
| IP Rating | IP67 |
| ATC | Yes |
| Accuracy | ±1% of reading |
| Calibration Points | 1 point |
| Battery Type | 4 x AAA batteries |
Turns instrument on; selects mode and unit preferences.
Provides access to battery for replacement.
Holds pen to shirt pocket for secure storage.
Indicates life remaining in battery.
Shows measurements, menu options, and battery indicator.
Indicates dipping, measurement progress, and removal.
Measures hydrogen ion concentration of solution.
Contains storage solution to maintain sensor hydration.
Used to hold sample solution when dipping is not possible.
Allows hands-free portability via belt strap.
Attaches through hole in top of pocket clip.
Allows selection between Celsius (°C) and Fahrenheit (°F) for temperature display.
Allows selection between Hold (stabilized) and LIVE (real-time) measurement modes.
Details LED signals and steps for taking pH measurements.
Ensures proper buffer solutions and sensor cleanliness for calibration.
Step-by-step guide for calibrating using pH 7, 4, and 10 buffers.
Guide for calibrating using pH 7 with either pH 4 or 10 buffers.
Procedure for calibrating using a single buffer (pH 7, 4, or 10).
Resets the unit to default factory calibration settings.
Instructions for replacing the N type battery.
Procedures for rinsing the sensor and using the soaker cap.
Instructions for removing and installing the pH sensor.
