05
FINESSEFINESSE
04
1.0 Warnings & Safety Information (cont...) 2.0 General Information
l
This appliance is a sealed electric radiator
designed for fixed wall-mounted installation.
l
This appliance conforms to the standards EN
60335-1 and EN 60335-2-30.
l
This appliance is class I and splash resistant
(IP44).
l
This appliance complies with the European
Directive 2014/30/EU (CE Marking on all
appliances).
l
This unit is supplied complete with a
connection cable and wall brackets.
3.
Room Temperature Sensor
Cable Hook Assembly
3.0 Warranty
The product is covered by a 2 year warranty
from date of purchase.
2. Power On/Off Switch
1. Thermostat Control
4.
Power Cable
CAUTION
Some parts of this
product can become
very hot and cause burns.
Particular attention has
to be given where
children and vulnerable
people are present.
In order to avoid
overheating, do
not cover the radiator.
“Do not cover” means
that the radiator must
not be used for drying
clothes, for example,
by placing them directly
on the radiator.
IMPORTANT SAFETY
INSTRUCTIONS!
Before starting work disconnect power supply!
All installation work and wiring work related to the
radiators, thermostats and programmers must be
carried out only when de-energized.
The appliance should be installed by and
commissioned by qualified professionals only.
Make sure to adhere to valid safety regulations.
Any repairs or maintenance within the warranty
period should be carried out only by approved
service engineers confirmed by MYSON.
For the correct installation of radiators it
is essential that the fixing of the radiator is
carried out in such a way that it is suitable
for intended use AND predictable misuse. A
number of elements need to be taken into
consideration including the fixing method
used to secure the radiator to the wall, the
type and condition of the wall itself, and any
additional potential forces or weights, prior
to finalising installation. IN ALL CASES IT IS
STRONGLY RECOMMENDED THAT A SUITABLY
QUALIFIED PROFESSIONAL INSTALLER
OR SIMILAR TRADESPERSON CARRIES OUT
THE INSTALLATION.
PLEASE NOTE: The fixing materials provided are only
intended for installation on walls made of solid wood,
bricks, concrete or on timber-frame stud walls where the
fixing is into the timber. All walls being considered should
have no more than a maximum of 3mm wall finishing.
For walls made of other materials, for example hollow
bricks, please consult your installer and/or specialist
supplier. ONCE AGAIN, IF YOU ARE UNSURE, IT IS
STRONGLY RECOMMENDED THAT A SUITABLY
QUALIFIED PROFESSIONAL INSTALLER OR
SIMILAR TRADESPERSON CARRIES OUT THE
INSTALLATION.
The radiator is equipped with an overheat
protection that cannot be reset (melt fuse). This
overheat protection disconnects the current if
the radiator becomes too hot (e.g. when covered).
If the supply cord is damaged, it must be replaced
by the manufacturer, his service agent or similar
qualified persons in order to avoid a hazard.
The radiator is filled with an exact amount
of environmental friendly vegetable oil. Any
repairs that require the radiator to be opened
shall therefore only be carried out by the
manufacturer or his approved agent. Please
contact MYSON in case of leakage.
To Next Page
Loading...
