MyTek Brooklyn Bridge - Rear Panel

8 Mytek Brooklyn Bridge
5.2 Rear Panel
1. Balanced XLR Stereo Analog Output
2. RCA Stereo Analog Output
3. RCA Stereo Analog Input
4. Phono ground connector when turntable is used
5. Optical Input (TOSLINK). Digital input which accepts up to 192kHz/24bit. Accepts DSD DoP
standard input up to DSD64. This input can also be used to transmit digital audio into computer
via USB2 connection. For best results use short high quality TOSLINK cable. Special glass ber
TOSLINK cable allows for longer cable runs and is less jittery than regular plastic ber
6. Ethernet port. Allows you connecting RJ-45 type cable (min. cat5 required)
7. USB-A 2.0 port. Accepts pendrives and 2.5” HDD. Maximum load 500mA
8. S/PDIF Coaxial Input 1 and S/PDIF Coaxial Input 2. These are digital inputs which accept up to
192kHz/24bit. They also accept DSD DoP standard input up to DSD64. This input can also be
used to transmit digital audio into computer via USB2 connection. To obtain best results, use a
high quality 75 Ohm digital RCA interconnect cable
9. Mytek proprietary USB 2.0 Class 2, up to 32bit/384k, DSD256, also accepts digital SPDIF and
TOSLINK inputs
10. Trigger I/O connector. The Brooklyn Bridge is fully compatible with popular trigger, HiFi control
systems. When working as the input the voltage range of 3.3V – 24V is accepted. When working
as the output it feeds 12V in this state. This connector is compatible with 3.5mm, 2 pole (tip
and sleeve) jack plug only
mono plug diagram
GND
sleeve
tip
trigger I/0
1
8
9
10
11
122 3 5
6
7 13
4