EasyManuals Logo

N-Com B1 User Instructions

N-Com B1
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
B1
15
10.2. Intercom function
To activate the intercom connection, turn on the two N-Com systems and briefly press
onon one of the helmets.
Intercom activation With B1 turned on, briefly press “on”.
Intercom deactivation With B1 turned on, briefly press “on”.
11. BATTERY
Before using the N-Com device for the first time, recharge the battery completely for at
least 10 hours. To obtain best performances from the battery, it is recommended to
completely recharge the battery the first few times. Afterwards, you can recharge the
battery for shorter periods. Whenever possible, it is best to recharge the battery
completely.
11.1. Battery discharged signal
When turned on, the system signals when the battery is running down by switching to the
Reserve” mode.
When the battery charging power falls below 1 hour of operation, the buttons ” and “
start to flash in order to indicate that the system is in Reservemode. Three consecutive
beeps also signal the reserve mode.
When the battery operates in “Reserve”, the system automatically turns itself off in case
no button is pressed for 30 minutes. The shutting off is signaled by a series of beeps in the
helmet. This function makes it possible to always have a small reserve of energy to use it
again in case you forget to turn off your helmet.
11.2. Recharging the system
To recharge the B1 system, connect the USB cable to a battery charger or to a powered
USB port. Charging occurs as follows:
B1 system turned off
When you connect the B1 system to the battery
charger, the blue LED begins to flash.
When the battery is fully charged, the blue LED stops
flashing and stays on.
B1 system turned on
When you connect the B1 system to the battery
charger, the red LED begins to flash.
When the battery is fully charged, the red LED turns off.
N.B.: If the device has not been charged for a long time (a few months), it may not be
possible to turn on the system during the first few minutes of the charging, as the
voltage may drop below the minimum limit.

Other manuals for N-Com B1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the N-Com B1 and is the answer not in the manual?

N-Com B1 Specifications

General IconGeneral
BrandN-Com
ModelB1
CategoryHeadsets
LanguageEnglish