N-Com B1 User Instructions

B1
7
3. INSTALLATION
You can download the installation video from www.n-com.it N-Com / Download section.
Fig. 1
 Open the small door on the e-box and
place the rechargeable battery inside
the system, making sure it is inserted
in the right direction (Fig.1)
 Before you install the B1 system on the helmet, make sure it turns on properly. Press
the “on” key for about 2 seconds, until the LED lights up and you hear a beep in the
headset. Proceed with the installation.
 Remove the cheek padding (see helmet instructions).
Fig. 2
 Remove the helmet edge gasket using
the special tool (Fig. 2).
 Remove the “N-Com” plugs found at
the back of the shell gasket and on
the left side of the helmet (Fig. 2).
Fig. 3
 Completely remove the gasket as
shown in Fig. 3; by doing so you also
remove the padding.

N-Com B1 Specifications

General

Brand	N-Com
Model	B1
Category	Headsets
Language	English