N-Com B901 - Smart Navi System; Managing Two Mobile Phones; Music via Bluetooth

EN
16
5. CONFIGURATION MENU
All Bluetooth pair ups and other adjustments are carried out in this mode.
To put the system in “Configuration mode” (starting from a switched off system) press the “ON” key
and keep it pressed for 4 seconds, until you hear the voice announcement “ Configuration ”.
Once in the “Configuration” menu, press the keys“” and “” to scroll through the various menu
items.
In the items marked with an “*”, it is possible to enable / disable the function or carry out the
commands by pressing the “ON” key to confirm.
The following items make up the “Configuration” menu:
A. Mobile phone pairing (chapter 6)
B. Intercom pairing (chapter 13)
C. Universal Intercom pairing (chapter 14)
D. Second mobile phone pairing (chapter 8)
E. Remote control pairing (chapter 15)
F. Speed dial* (chapter 7.1)
G. Audio boost *
By enabling the “Audio boost” (Audio Boost), all the audio sources inside the device will be
reproduced at a higher and potentially less clear volume.
Press the “ON” confirmation key to enable / disable the function, which is not enabled by
default on the device.
H. Delete all pairings*
In order to delete all Bluetooth pair ups stored in the device, press the key “” or “” until
you hear the voice announcement “ Delete all pairings ”.
Press the “ON” confirmation key to delete all Bluetooth devices stored in memory.
I. Reset*
In order to restore the factory settings of the device, press the key “” or “” until you hear
the voice message “ Reset ”.
Press the “ON” confirmation key to restore all the factory settings of the device.
J. Exiting the configuration*
To exit the “Configuration” menu, press the key “” or “” until you hear the voice
announcement “ Exit the configuration ”.
Press the “ON” confirmation key to exit the “Configuration” menu.
If no key is pressed within 10 seconds, the device automatically exits the “Configuration” menu.